10mm Washable DIP Rotaries
General Specifications
Electrical Capacity (Resistive Load)
Series DR
Switching Rating:
Nonswitching Rating:
Other Ratings
Contact Resistance:
Insulation Resistance:
Dielectric Strength:
Mechanical Life:
Electrical Life:
100mA @ 5V DC
100mA @ 50V DC
80 milliohms maximum for all 4 contacts closed
30 milliohms maximum for 1 contact closed
1,000 megohms minimum @ 250V DC
250V AC minimum for 1 minute minimum
20,000 detent operations minimum
20,000 detent operations minimum
Note: A detent operation is one actuator position operation or stepping.
20,000 detent operations = 1,250 cycles for hexadecimal devices or
2,000 cycles for decimal devices. A cycle is one 360 ° rotation.
Nominal Operating Torque:
Contact Timing:
Materials & Finishes
Shaft & Bushing (DRA only):
Actuator:
Housing & Case:
O-rings:
Base:
Movable Contact:
Stationary Contacts:
Terminals:
Environmental Data
Operating Temp Range:
Humidity:
Vibration:
Shock:
Installation
Mounting Torque for DRA:
Knob Installation Force:
Soldering Time & Temperature:
Process Seal:
Standards & Certifications
Flammability Standards:
UL Recognition
or CSA Certification:
80 ~ 320 grams-cm (1.1 ~ 4.4 ounce ? in)
Shorting (Avoid possible false signal by turning off power before switching.)
Brass with nickel plating
Glass fiber reinforced polyester (PBT) (UL 94V-0)
Glass fiber reinforced polyester (PBT) (UL 94V-0)
Nitrile butadiene rubber
Glass fiber reinforced polyester (PBT) (UL 94V-0)
Copper with gold plating
Phosphor bronze with gold plating
Phosphor bronze with gold plating
-25 ° C through +75 ° C (-13 ° F through +167 ° F)
90 ~ 95% for 96 hours @ 40C ° (104 ° F)
10 ~ 55Hz with peak-to-peak amplitude of 1.5mm traversing the frequency range
& returning in 1 minute; 3 right angled directions for 2 hours
50G (490m/s 2 ) acceleration (tested in 3 right angled directions, with 3 shocks in each direction)
1.47Nm (13.0 lb ? in) for double nut; .686Nm (6.08 lb ? in) for single nut
39.2N maximum (8.82 lbf) for DRA model; 29.4N maximum (6.61 lbf) for DRF/DRF2 models
3 seconds @ 350 ° C manual soldering or 5 seconds @ 270 ° C solder pot
See Supplement Index (page Z2) for specific processing data.
UL 94V-0 rated actuator, housing, case, & base
The DR series rotaries have not been tested for UL recognition or CSA certification.
These switches are designed for use in a low-voltage, low-current, logic-level circuit.
When used as intended in a logic-level circuit, the results do not produce hazardous energy.
NKK Switches ? email: sales@nkkswitches.com ? Phone (480) 991-0942 ? Fax (480) 998-1435
www.nkkswitches.com
8-03
相关PDF资料
88970413 CONTROL REMOTE DSPLY KEYPD W-CBL
561-1301-080 LED 5MM VERT LOW CUR GREEN PCMNT
HWK30000 KIT BEZEL HWK30000 + DATA
ASA-8.000MHZ-L-T OSC 8.000 MHZ 3.3V SMD
78C10SRAT SWITCH DIP RAISE SLIDE SEL 10POS
551-2507 LED ORANGE PCB RA 3MM
78C09SRAT SWITCH DIP RAISE SLIDE SEL 9POS
561-2601-070 LED 5MM VERT HIEFF TINT YEL PCMT
相关代理商/技术参数
DR-FC10P 制造商:NKK Switches 功能描述:
DRFC16H 功能描述:旋钮开关 RO 633-FR01FC16H RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DRFC16P 功能描述:旋钮开关 RO 633-FR01FC16P RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DRF-NJG-V2W-1 制造商:DOMINANT 制造商全称:DOMINANT Semiconductors 功能描述:High brightness surface mount LED
DRFR10H 功能描述:旋钮开关 SLOTTED BCD R/A RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DR-FR10H 制造商:NKK_SWITCHES 功能描述:
DRFR10P 功能描述:旋钮开关 RO 633-FR01FR10P RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
DR-FR10P 制造商:NKK Switches 功能描述:DR Series SP10T 0.1 A 5 VDC 10 mm Through Hole Washable DIP Rotary